Luca
c32c4645b5
Tooling and findings for running an E8x/E9x electric power steering unit
outside its donor car, e.g. in an EV conversion.
Headline result: the EPS needs only two CAN messages plus a 12V enable
wire, not the 69-message set the car puts on the bus:
0x130 CAS terminal status (100ms) brings the unit up
0x1A0 DSC road speed (20ms) sets the assist level
Total required rate is 60 frames/s. Protocol write-up, including what is
proven vs. inferred and the open questions, is in eps-comms/.
Contents:
adapters/ CANdapter (its SLCAN dialect differs) and generic SLCAN
gateway/ car<->EPS relay, replay, message bench, EPS controller,
4-tab Streamlit UI
decoder/ PT-CAN frame decoding and live/replay sources
can-io/ XIAO ESP32-S3 firmware: CAN IO board + USB-CAN bridge with
a CAN-independent digital IO channel
tools/ capture, bitrate scan, startup-order and session analysis,
checksum solver
captures/ reference working session + the replay set eps_control reads
4 lines
119 B
JSON
4 lines
119 B
JSON
{
|
|
"car_to_eps": {"default_allow": true, "overrides": {}},
|
|
"eps_to_car": {"default_allow": true, "overrides": {}}
|
|
}
|